Mangosteen Cleanser: Microcurrent Routine Guide
By 7E Wellness | Published: 2026-10-18
Category: How-to Guides
Learn how to use the Mangosteen Cleanser in your microcurrent routine for clean, conductive skin and better results.
Quick Answer
Use the Mangosteen Cleanser as your first step before applying conductive gel or serum to ensure your skin is free of oil, makeup, and debris so the microcurrent can conduct properly.
Why Clean Skin Matters for Microcurrent
Microcurrent devices work by sending low-level electrical currents through the skin to stimulate facial muscles and improve tone. For the current to flow evenly, your skin must be completely clean. Residue from makeup, sunscreen, or previous skincare products can block conductivity, leading to uneven results or a tingling sensation.
The Mangosteen Cleanser uses mangosteen extract, which is rich in xanthones—potent antioxidants that help reduce inflammation and improve overall skin health. This makes it a smart choice for prepping skin before microcurrent, as it cleans without stripping and adds a layer of antioxidant protection.
How to Use Mangosteen Cleanser with Microcurrent
- Step 1: Remove Makeup and Sunscreen: If you are wearing makeup or water-resistant sunscreen, use a gentle oil-based or micellar cleanser first to break down those layers. The Mangosteen Cleanser is not designed to remove heavy makeup on its own. Skipping this step can leave a film that blocks conductivity.
- Step 2: Apply Mangosteen Cleanser to Damp Skin: Wet your face with lukewarm water, then apply a pea-sized amount of the Mangosteen Cleanser. Gently massage in circular motions for about 30 seconds, focusing on areas where you tend to hold oil or makeup residue. Avoid using hot water—it can irritate the skin before microcurrent.
- Step 3: Rinse Thoroughly and Pat Dry: Rinse with lukewarm water until no cleanser remains. Use a soft, clean towel to pat your skin dry—do not rub. Your skin should feel clean and slightly refreshed, not tight or dry. Leftover cleanser can cause the conductive gel to slide off unevenly.
- Step 4: Apply Conductive Gel or Serum: Once your skin is clean and dry, apply a thin, even layer of your preferred conductive gel or serum. This step is essential for the microcurrent device to glide smoothly and conduct the current effectively. Do not apply the cleanser as a substitute for conductive gel—it won't provide the same conductivity.
- Step 5: Proceed with Your Microcurrent Treatment: Use your microcurrent device according to its instructions. The clean, prepped skin will allow the current to travel evenly, and the antioxidants from the cleanser can help minimize any temporary redness after treatment. If you feel a sharp or uneven sensation, pause and check that your skin is fully clean.
Product Facts
- Mangosteen Cleanser: This cleanser is made from Mangosteen, also known as the 'Queen of Fruit.' Compared to other fruits, Mangosteen has the highest level of Xanthones (a potent antioxidant) which helps to improve the overall health of skin, prevents inflammation, and improves the complexion. Using an antioxidant-rich cleanser before microcurrent not only removes impurities but also delivers protective compounds that help calm the skin and reduce post-treatment redness.
Mangosteen Cleanser
