How to Use Peptide Serum with MyoLift Treatments
By 7E Wellness | Published: 2026-10-27
Category: How-to Guides
Learn the correct order to layer peptide serum with MyoLift microcurrent devices for better anti-aging results. Avoid common mistakes that reduce conductivity or product effectiveness.
Quick answer
Apply peptide serum as a middle layer between clean skin and conductive gel during MyoLift microcurrent treatments to maximize anti-aging benefits without interfering with device conductivity.
Why layering order matters
Peptide serums are water-based and absorb quickly, but they lack the conductivity needed for microcurrent devices. Placing them directly under the device electrodes can cause uneven current flow and reduce treatment effectiveness.
Conductive gel, on the other hand, is designed to transmit microcurrent evenly. By applying peptide serum first and then sealing it with a thin layer of conductive gel, you get both the active ingredients and proper conductivity.
When to skip peptide serum before microcurrent
If your peptide serum contains oils, silicones, or thick emollients, it may block microcurrent from reaching deeper skin layers. In that case, apply the serum after your MyoLift session instead.
Always check your serum's ingredient list. Water-based, lightweight formulas work best before microcurrent. Heavy creams or balms should be used post-treatment.
Step-by-step: Peptide serum with MyoLift microcurrent
- 1. Cleanse and dry your face: Remove all makeup, oil, and sunscreen. Pat skin completely dry. Any residue can block peptide absorption or interfere with conductivity. Skip toner or acid exfoliants right before microcurrent—they can sensitize skin.
- 2. Apply peptide serum evenly: Dispense 2-3 drops of peptide serum onto fingertips and press gently into clean skin. Cover your entire face, neck, and eye area. Wait 30-60 seconds for partial absorption. Don't rub vigorously; peptides are delicate and can break down with friction.
- 3. Layer conductive gel over the serum: Apply a thin, even layer of conductive gel (such as MyoLift ATP Booster Gel Mask) over the serum. This creates a slip layer that allows the microcurrent device to glide smoothly and conduct electricity properly. Too much gel can dilute the serum; too little can cause stinging or uneven current.
- 4. Perform your MyoLift microcurrent treatment: Use your device according to its manual, moving in upward and outward strokes. The peptide serum will be driven deeper by the microcurrent while the gel ensures consistent conductivity. Keep the device moving—never hold it still on one spot for more than a few seconds.
- 5. Rinse and follow with moisturizer: After the treatment, rinse off any remaining gel with lukewarm water. Pat dry and apply a moisturizer or night cream. Your skin is now primed to absorb additional hydrating ingredients. Avoid washing with hot water or using active serums (vitamin C, retinol) for at least 30 minutes post-treatment.
Product facts
- Peptide Serum for Face: Anti-Aging & Hydrating Wholesale: Contains copper peptides, polypeptides, and hyaluronic acid to help remove fine lines and wrinkles from the face, neck, eyes, and smile lines. These ingredients are best absorbed when applied before microcurrent, as the current can help drive them deeper into the skin for enhanced anti-aging effects.
Peptide Serum for Face: Anti-Aging & Hydrating Wholesale
